The silicone cleansing brush custom difficulties

by:Keyuan     2020-09-11
Silicone skin cleaning brush customization production difficulties 1, mold design difficulties in the production process of because the entire facial brush head is dense, coupled with the back of the product have a suction cups, so mould design more difficult. 2, demoulding cause adverse each product in the stripper is you need to use hand pull to release, so the hard to avoid can make the face brush head and bottom of the chuck was bad. The second is the diameter of the brush head in zero distance. 8 mm less than 1 mm spacing between plus brush is too narrow, so the production of brush a head wind and fracture occurs. Silicone skin cleaning brush custom common problem 1, most of the time the cause of the poor also have different requirements on skill, so easy to be pulled when pulling should let workers pay attention to use proper strength, due to the silicone brush facial cleaning mold core shuttle in the middle parts of the skin cleaning brush, so the tensile force pulling causes product base, 2, the second is as far as possible in the mold will slow the rate of the mold, don't let the brush head of fracture in the mold, because the brush head is too fine after fracture with the naked eye can't see if it's broken, and in the case of neglected tend to appear a few hours in a row, even bad phenomenon, so after the mold is seriously look at the mold whether the brush head is complete. 3, to brush a head wind phenomenon, as long as the basic will not appear within a certain temperature and time, just after the mold too slow prone to package the wind phenomenon of the operation.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...