The most thick silicone products size, shrinkage, dimensional accuracy and shape what is negative deviation

by:Keyuan     2020-12-05
Silicone products small white science, silica gel products limit of size, shrinkage, dimensional accuracy and shape design, respectively, limit of size: can be done in the thickest place 15 ~ 20 mm, for 40 to 50 degrees of material, usually take 1. 03 shrinkage A and limit of size: most can do 15 ~ 20 mm thick, if it is A sphere, can do 30 mm in diameter. Generally recommended size is not greater than 3 mm thickness, when greater than 3 mm, will cost more vulcanization time and increase the cost. The thinnest place theory can reach 0. In the design of 2 mm, but take the thinnest commonly 0. 3 mm, recommend the 0. 4MM。 B, relative size: differences in thickness, the thinnest and the thickest in suggested that not more than three times. Such problems when sulfide mainly depends on the material requirements for temperature and pressure. C, shrinkage, shrinkage is associated with the hardness of the material of the silicone material, manufacturers provide more in 1 time. 022-1. 042 between, for 40 to 50 degrees of material, usually take 1. 03 shrinkage. Relative to the plastic, silicone products will not produce similar apparent surface defects by shrinking. D, dimensional accuracy: by the size of the silicone products for more than a mold cavity, relative to the hole very much plastic products. So there is no plastic products as convenient size control. The general accuracy of plus or minus 0. 1, high precision products of plus or minus 0. 05. When cooperate with plastic parts when the fit between the hole and buttons, the minimum clearance to take unilateral 0. 1, the recommended value for unilateral 0. 2. E, appearance design, for glue set of parts, generally according to the appearance of product figure for the original figure can be supplied by the mold factory, cooperate to explain the problem, the mold factory's discretion. In general, depending on the product size, plastic cover with products for unilateral commonly small 0. 2 to 0. 5 the negative deviation. Above is a limit of size about the silicone products, shrinkage, dimensional accuracy and shape design of related to arrange, hope everyone to silicone products have a deeper understanding of, choose the silicone products factory in foshan, foshan area can consider rubber plant 10 old factory professional and more efficient.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...