Many friends are in trouble when it comes to choosing a lot of rubber products, for plastic, silicone, rubber, PU, PC material such as silly points not clear, I don't know what kind of material is practical and environmental protection.
But with some smart products in recent years, as well as the emergence of the creative stuff put intelligent products and electronic product trend gradually pushed to the forefront, and facing the do not know much about the quality of the production process and the use of material selection of the small white is confused about, tell not clear the correct choice silicone products and plastic products is good, then today to reveal their differences and advantages and disadvantages of different!
First used by silica gel and the classification of plastic special process is also different, from the silica gel products manufacturer for silicone material we are using a lot of articles for daily use food grade high transparency silicone material, it is also is a kind of rubber and plastic material, not too early in the 19th century has been studies have shown that it belongs to the rubber material of the environmental protection basic no harm a synthetic rubber, environmental non-toxic, because the material is superior in when simple production process, such as liquidity and anti senile than the plastic material is superior, the above process cost is lower than plastic, secondary flow molding products after epidemic, elasticity, tensile, tear resistance will gradually in the process of use of the product, outstanding advantage is belongs to the non-toxic environmentally friendly products, not any conflict to the body, the disadvantage is that permeability is bad, can produce electrostatic adsorption force is too strong!
Belong to our common PU plastic material, PC material, such as when the manufacturer production using extrusion process, molding, blow molding process, the main advantages are wear-resisting, oil resistant, transparent, good elasticity, excellent electrical insulation, extensibility, dimensional stability and resistance to chemical corrosion resistance, heat resistance and cold resistance, also has the advantages of self-extinguishing, flame retardant, can be colored.
Also meet the requirements of product function, quality and appearance etc, the design must be made of plastic injection mould processing is simple, low cost, and parts of injection time is short, high efficiency, less defect parts, high quality, which is oriented to the design of the injection molding processing.
This section will in detail design guidelines for plastic parts, makes the design of plastic is oriented to the design of the injection molding processing.
And silicone rubber products different is shading problem, at the same time in the deployment of compound solvent part without equal compound polyvinyl chloride (PVC) is your release harmful substances secreted interference for element, endangering the safety issue.
Com/rubber products factory in xiamen -
Silica gel products co. , LTD. (